 |
 |
 |
 |
 |
 |
 |
Phone: 415-382-1669
Fax: 415-382-9069
21 Pamaron Way, Ste G
Novato, CA 94949
rfq@omwcorp.com
|
|
|
| This difficult-to-machine manufacturing robotics part was turned and milled from 303 stainless steel. Note ends are not round!
|
An manufacturing assembly prototype machined from 6061 AL and anodized. 3D surface machining was used for the complex angled grooves.
|
 |
 |
Prototype laboratory part machined from solid 6061 aluminum. The part is a nearly 16" cube.
|
A very complex electronic heatsink machined from 2024 aluminum. Custom ground tooling was used to create the small cone shapes.
A small part with complex curves machined from aluminum.
|
 |
A difficult aerospace prototype is machined on a 5-axis tilting rotary table.
 |
A prototype mold for a consumer product, 3D machined in single quantity from aluminum billet.
|
An assembly die machined and ground to .0002" tolerances in hardened tool steel with an aluminum base.
|
| A new prototype door handle is 3D machined from a solid brass block for a
major lock company. Note the work is "tabbed" in the block and will be cut away
later in the band saw. Work was programmed in SurfCam by OMW Corporation.
|
Finished handles and plates, ready to ship to customer.
|
 |
 |
Prototype electronic remote control unit. Machined from solid ABS
plastic in three pieces. 3D programming in SurfCam and FeatureCam.
|
A large chainring custom machined from 7075 Aluminum for a high
performance human powered vehicle.
Radiation test equipment parts machined from solid billet, in two halves.
Inside view of above parts, showing split halves.
In addition to metals, OMW has extensive experience in precision
machining a wide variety of engineering plastics.
|
 |
To see production machining sample images, click here
|
